STEP 1

Turn off the laptop and remove the battery.

There are four rubber screw seals on the screen bezel.
Remove all four seals and screws found under them.

STEP 2

You can remove the screw seal with a sharp object or small flat head screwdriver.
Glue seals somewhere on the bezel so they don't get lost.

STEP 3

Start separating the screen bezel from the display cover on the side.

STEP 4

You can use a guitar pick or another piece of soft plastic to separate the bezel.

STEP 5

Continue separating the screen bezel on the top of the display panel.

STEP 6

Use a screwdriver to separate the bottom part of the bezel.

STEP 7

The screen bezel has been removed.

STEP 8

The screen inverter board is mounted below the screen.
I'm not replacing the inverter board so I'll leave it attached to the display cover.

Remove the screen backlight cable from the right side of the inverter board.

STEP 9

Remove eight screws securing display hinges.

STEP 10

Remove two screws securing the LCD screen on the top.

STEP 11

The wireless antenna and webcam cables on the right side of the display panel are secured by three foil strips.
Unglue foil strips as it shown on the picture.

STEP 12

Do the same with four foil strips on the left side of the display panel.

STEP 13

Disconnect the black cable from the web camera module.
You will not be able to separate the screen from the cover without disconnecting this cable.

STEP 14

Separate the display cover from the LCD screen assembly.

STEP 15

Now you can access the video cable connection on the back of the screen.

STEP 16

Disconnect video cable from the connector on the LCD screen.

STEP 17

Remove three screws from both sides of the LCD screen.
These screws secure the LCD screen to the mounting brackets.

STEP 18

Remove the LCD screen and replace it with a new one.

STEP 19

You can search for a new screen using the LCD screen model number (LTN160AT01 in my case) or Toshiba part number (K000065920 in my case).

In the next guide I explain how to take apart the body.